4 Easy Steps

 1. Pop off the caps with a flat head screw driver.

1. Pop off the caps with a flat head screw driver.

 2. Put the o-clamp into the screw whole (remove the butterfly screw). Turn and tighten until parallel.

2. Put the o-clamp into the screw whole (remove the butterfly screw). Turn and tighten until parallel.

 3. Center and insert the alloy x1 pole to the o-clamps.

3. Center and insert the alloy x1 pole to the o-clamps.

 4. Tighten and enjoy.

4. Tighten and enjoy.

 

3 Helpful Notes

1. Check your tripod owners manual for manufactures suggested weight it can safely support. Ensure you spread your tripod legs wide enough to avoid tipping over. 

2. Balance lights on the left and right side of the speaker to ensure even weight distribution.

3. By Purchasing the “Alloy X1 Series” you, the buyer,  assumes all liability inherent in any situation, thereby relieving Local Boy of any responsibility. Local Boy LLC is not responsible for misuse or any injuries that may occur. This product is to be used by the buyer responsibly and safely.